News | add2

Latest news

If you’re looking for the very latest information on add2’s products and services, this is the place to find it. Check back regularly for information on events the company is attending, software releases, product launches and more.

Easily access up to 90 signal paths with add2 Breakout Box

Posted in Automotive, Distributed systems, Hardware in the loop

During verification testing of production intent components, it is frequently necessary for engineers to gain physical access to multiple signals for various diagnostic purposes but often, solutions to...

Read More
COMMDongle Pro and Lite

Interfacing to CAN? Watch how to easily analyse CAN Bus messages

Posted in Automotive, CAN interfacing

If you need to keep your toolbox lightweight, small and yet robust, then COMMDongle interfaces can help. The range is designed for test development engineers or students...

Read More

How to easily perform whole-vehicle current diagnostics

Posted in Automotive, Vehicle current measurement

In modern vehicles there has been a significant increase in the number of electronic hardware devices connected to the vehicle battery, each of which has the potential...

Read More

Switch between vehicle test programs in minutes with Genix Test Unit

Posted in Automotive, Production testing

An upgrade is now available for our Genix Test Unit to allow firmware changes to take place on the factory floor.  As each new vehicle model year...

Read More
Engine Cranking

How to isolate embedded control faults in minutes: Watch now

Posted in Automotive, LVTGO-VBS

As the complexity and number of in-vehicle electronic controllers increases, so does the likelihood of their failure, especially during cranking or start/stop scenarios. When a fault does...

Read More

How to easily repurpose HIL environments

Posted in Automotive, Hardware in the loop

With vehicle functionality advancing at a rapid rate, there is a much greater level of complexity involved in testing pre-production electrical systems. Modern cars can contain over 150 million...

Read More

How dynamic powertrain signalling greatly improves your yellowboard test coverage

Posted in Automotive, Production testing

For years, much electronic automotive testing has been carried out on lab cars or yellowboards. Traditional automotive test boards consist of a metal framework, often taking the...

Read More

Production testing of passive entry sensors now available

Posted in Automotive, Production testing

Latest developments to the Genix Test Unit allow for presence and correct engineering revision testing of passive entry sensors. Automotive sub-assemblies such as bumpers and spoilers typically...

Read More

add2 announces partnership with Warwick Racing

Posted in Partners and announcements

add2 are delighted to announce a sponsorship agreement with the Warwick Racing team, based at the University of Warwick. The team will be sponsored by add2 throughout the 2017/18...

Read More